For the first time get a high precision pressure controller and a pressure source in the same equipment

A line of pressure controllers dedicated to microfluidics including a pump and a high accuracy pressure controller in the same equipment. Several  ranges of pressures and precisions available:

A large pressure controller:  precision 1 mbar, pressure range up to 1,6 bar.

A high precision pressure controller: precision 100µbar, pressure range up to 300 mbar.

A vacuum pressure controller:  precision 1mbar, pressure range down to -600 mbar.

Autonomous: This pressure controller is coupled with an autonomous pressure pump, no need for compressor/gas line

Transportable: weight  1.2kg, small size: 15x15x20 cm

Quick setup: Install your pressure controlled microfluidic experiment in 5 min for the first installation, setup a new experiment in 2 minutes

Accurate: Pressure controller down to 100µbar  tuning precision ( 0.0145 psi )

USB control option: Control your pressure controller with your computer using Elveflow® proprietary software (optional)

4 independent outlets pressure controller: Get four independent outlets for your Elveflow® pressure controller (optional)

Both pressure and flow rate control and monitoring: No more need to choose between pressure controller or syringe pump (optional)

An intuitive high precision pressure controller for a fast microfluidic setup installation

Depending on your experiment requirements, there are two options to control your microfluidic experiment with the Elveflow® pressure controller.
.

When using directly air pressure in your microfluidic device:

(Exemple of applications: microfluidic valve control)

Step1-2:  Plug the Elveflow® pressure controller to an electric plug and turn it ON.

Step 3: Plug your microfluidic chip to the Elveflow® pressure controller

Step 4: Turn the knob of your Elveflow® pressure controller to set the desired pressure

Step5:  Switch ON the valve of the Elveflow® pressure controller to put the microfluidic chip at the desired pressure.

At any time you can change the pressure inside the microfluidic chip by turning the knob of the Elveflow® pressure controller.
.

If you want to perform flow control of liquids inside you microfluidic device:

(Examples of applications: droplet generation, cell culture medium renewal)

Step1-2:  Plug the Elveflow® pressure controller to an electric plug and turn it ON.

Step 3: Plug your Elveflow® pressure controller to a liquid tank*.

Step4: Connect your microfluidic device and the reservoir.

Step 5: Turn the knob of your Elveflow® pressure controller to set the desired pressure.

Step6: Switch ON the valve of the Elveflow® pressure controller to put the microfluidic chip at the desired pressure.

At any time you can change the pressure inside the microfluidic chip by turning the knob of the pressure controller.

*for more convenient use you can use our microfluidic liquid reservoirs.