Kit fittings starter pack luer

Contains everything to hook-up a pressure source to the OB1 controller, the controller to the reservoirs (not included) and the reservoirs to the chips:

• Set of fitting adaptors to connect your pressure source to the 6mm pipe input of the OB1
• Male Luer Integral Lock Ring Plug (x10) Male Luer Integral Lock to 3/32″ OD Barb (x10)- 4mm OD PU Tubing (5m) to connect pressure/vacuum Luer output of the OB1 to the tubes
• PUR polyether clear 4mm OD tube (5m) to go from the OB1 to the reservoir
• 1/4″-28 Thread to 3/32″ OD Barb (x10): fittings to connect the tube from the OB1 to the reservoir
• BLUE PFA Nuts Flangeless 1/4″-28 Fitting for 1/16″ Tubing with ETFE Ferrules Flangeless 1/16″ (x10): fittings to connect the output from the reservoirs or the inputs of the sensor to the 1/16” OD tubes
• PTFE Tape for Sealing (1 max per parcel): helps to ensure a perfectly sealed connection
• PTFE Teflon Tubing Spare Roll 1/16″ OD x 1/32 ID (50m): going from the reservoir to your application
• Set of flow resistances :
  • 1/16 OD PEEK Tubing , 50 µm ID (x 20 cm) , 65 µm ID (x 20 cm) , 100 µm ID (x 20 cm) , 250 µm ID (x 20 cm) : set of flow resistance to help you finely tune your setup
  • 1/4-28 to 1/4-28 internal threads Standard Union (x 2): to connect different pieces of tubes or flow resistances together
  • Microfluidic Tubing Cutter (x 1): to ensure a clean cut of the resistance
• Filter 5µm Luer Lock (hydrophilic, max pressure 6 bar) to filter your solution if needed