How to perform stop flow in a microchannel using a MUX Cross Chip
At a glance
This application note describes how to generate a controlled flow in a microfluidic chip and stop it using an OB1 pressure controller and a MUX Cross Chip. The main stages are removing air bubbles, injecting the sample with a syringe and T-junction, applying positive or negative flow, then balancing the pressure between chip inlet and outlet. In the described setup, this balancing stops the flow almost instantaneously.
- Observed result
- Flow stopped almost instantaneously by balancing pressure between chip inlet and outlet using the OB1
- Sample requirement
- Sample miscible in the buffer medium and of the same density, for good zero flow performance
- Bubble removal
- Required, since air bubbles contract or expand with pressure and prevent an instantaneous stop
- Chip and valves
- MUX Cross Chip, a matrix of 4 x 4 valves; Fluidic 268 chip from microfluidic ChipShop













